Heathkit IO-4205 - Page 21

The steps performed in this L torial ar e
in thi s area of the circuit bo ard
NOTE:
When you install a trimmer
capacitor, insert its end leaves into the
circuit board slots. Solder both sid es of
the
end leaves to the foil as you install
each trimmer. All
the leaves must be
soldered. Then cut off the excess leaf
lengths.
SO LDE R
' ' · ' ', '\ ~~~!~
. C IRCUIT BOARD
:4-40 pF trimmer (#31-54).
:4-40
pFtrimmer(#31-54) .
. 5-20
pF trimmer (#31-
:8 -60 pFtrimmer (#31-52).
:8-60
pF trimmer (#31-5 2 ).
f
--- --- -----1
I
1- - - - ~Jo m
PICTORIAL 1-8
Page 19
IDENTIFICATION
DRAWING
PART
NUMBER