Heathkit IO-4205 - Page 41

IDENTIFICATION
DRAWING
PART
23: 6.8
MD. (Blu-Gry-Grn).
24: 680
kn (Blu-Gry-Yel).
74:100 kn (Brn-Blk-Yel).
Solder
the leads to the foil and cut
off the excess lead lengths.
R262: 1000
!l (Brn-Blk-Red).
R256: 10
kn (Brn-Blk-Org).
5: 270 !l (Red-Viol-Brn).
2: 1000 n (Brn-Blk-Red).
R250: 1800
n (Brn-Gry-Red).
R248: 1500
!l (Brn-Grn-Red).
) R270: 10
!l (Brn-Blk-Blk).
) Solder
the leads to the foil and cut
off the excess lead lengths .
Page 39
-'l'A~--Th e steps performed in this Pictorial are
in this area of
the circuit board.
II
PICTORIAL 2-4
16: 1000 pF polystyrene. Match
the band (colored end) on the
capacitor with the band on the
circuit board.
R225: 68
kn (Blu-Gry-Org).
R226: 6800
!l (Blu-Gry-Red).
: 1000
!l (Brn-Blk-Red). .../
220 n (Red-Red-Brn). _.A
10 MD. (Brn-Blk-Blu) . .,..,
100 kn (Brn-Blk-Yel). /
560
!l (Grn-Blu-Brn).
59: 220
!l (Red-Red-Brn).
Solder the leads to the foil and cut
off the excess lead lengths.