12
11
F) Setting the floor limit temperature
If you have enabled the floor sensor probe, you need
to set the floor limit temperature. Should the floor
temperature reach this limit, the heating will be turned
off and will be displayed on screen.
• With the thermostat turned off, press H and Up arrow
key
• Use the Up/Down arrow keys to select the floor limit
temperature. 28 is the factory default.
• To store, press the Off button.
Viewing the Floor Temperature
Press and hold the A button to view the floor
temperature.
Temperature Override
Using the Up/Down arrow keys you can adjust the
current set temperature. On the screen, you will see
SET and the new temperature displayed.
This temperature will be maintained until the next
programmed comfort level.
Turning The Heating Off (Frost Protection)
By pressing the H button, the thermostat will switch
into frost protection mode. You will see a frost symbol
on screen.
The frost protection temperature will now be
maintained. To cancel, repeat the steps above.
To Next Page
Loading...
