Need help?Do you have a question about the Heatmiser SLIMLINE and is the answer not in the manual?
General| Display | LCD |
|---|---|
| Floor Sensor | Optional |
| Accuracy | ±0.5°C |
| Temperature Range | 5°C to 35°C |
| Power Supply | 230V AC |
| Type | Programmable |
| Switch Rating | 3A |
| Control Type | Digital |
| Compatibility | Underfloor heating systems |
Indicates the current temperature sensor mode.
Displays the current day.
Displayed when the thermostat is in frost protection mode.
Displayed when the thermostat is calling for heat.
When a Temp Hold is active, HOLD FOR and remaining time is displayed.
Indicates when changes are being made to programs or temperature set points.
Displayed when the thermostat is in holiday mode.
Indicates the current sensor temperature.
Displayed during programming only to show which period is being altered.
Displayed when the keypad is locked.
Degrees Celsius or Fahrenheit.
Digital clock display in 24h format.
Allows selection between °C and °F.
Adjusts the switching differential for heating control.
Sets whether frost temperature is maintained when display is off.
Temperature maintained when the thermostat is in frost mode.
Prevents rapid switching by setting an output delay.
Not used on this model.
Limits the use of the up and down keys for temperature adjustment.
Selects the sensor to be used (built-in or remote).
This function is not available on this model.
Delays heating start-up to ensure warmth at the programmed time.
Learns heat-up time to optimize heating efficiency.
Available modes: Non-Programmable, 5/2 Day, 7 Day.
Sets temperature units to °C or °F. Default is °C.
Sets switching differential from 01°-03°C. Default is 01°C.
Enables or disables frost protection. Default is Enabled.
Sets frost protection temperature range 07°-17°C. Default is 12°C.
Sets output delay from 00-15 minutes. Default is 00.
Not used on this model.
Sets temperature limit for Up/Down keys. Default is 00° - 10°C.
Selects sensor: Built-in Air Sensor or Remote Air Sensor.
Not used on this model.
Sets optimum start delay from 00-03 Hours. Default is 00.
Sets minutes to raise temperature by 1°C.
Sets program mode: Non-Programmable, 5/2 Day, or 7 Day.
To Next Page
