Heatrae Sadia Streamline 7 undersink User Manual

12
6.0 MAINTENANCE
WARNING: DISCONNECT FROM ALL ELECTRICAL SUPPLIES BEFORE
BEGINNING ANY WORK ON THE STREAMLINE. WATER CONTAINED IN
THE WATER HEATER MAY BE VERY HOT!
To ensure the continued safe and efcient operation of the Streamline it
should be regularly maintained.
Maintenance should be carried out by a competent person and any
replacement parts used should be Heatrae Sadia ‘Streamline’ spare parts.
Little maintenance is required, however in hard water areas the Streamline
may require periodic descaling to ensure efcient operation.
6.1 DRAIN THE STREAMLINE
1. Ensure the water and power supplies to the Streamline are switched off
and the water is cold.
2. Remove the thermostat knob (use a medium sized at bladed screwdriver
to carefully prise the thermostat knob from the front cover).
3. Remove the front cover (see section 3.3.3, p.7).
4. Disconnect the wires from the Element Plate Assembly (EPA).
5. Remove the capillary cut out and thermostat bulbs from the EPA.
6. Remove the front insulation.
7. Use a 5mm allen key to rotate the drain plug in an anti clockwise direction
through 180 degrees.
8. Use a medium sized at bladed screw driver to carefully prise the drain plug
from the inner container.
FIGURE 09 - DRAIN PLUG
DRAIN PLUG
OPEN
CLOSED
SCREW DRIVER RECESS

Heatrae Sadia Streamline 7 undersink Specifications

General

Brand	Heatrae Sadia
Model	Streamline 7 undersink
Category	Water Heater
Language	English