made for garden
16 / 72
EN
OPERATING
SAWING
• Place the wood in the feed carriage (rocker table)
• Press the green button to switch on the saw. Wait until it reaches full speed.
• Take hold of the carriage with both hands on the handle and move it towards the saw blade.
• Pressing the carriage releases the saw blade from the saw blade cover.
• Do not apply so much pressure to the feed carriage that the motor speed falls.
• After the cut has been completed return the carriage completely to its initial position.
• Remove the saw wood from the carriage .
• To turn the saw off again ,press the red button “O”.
i
Never switch on the machine again whilst it is slowing down.
If the wood cannot be sawn completely in a single cut, turn it over (reversing cut ).To
do this return the feed carriage to its initial position, turn the wood along the cut and
saw through it again.
i
Important: If the saw blade does not reach a standstill after a maximum of 10 seconds,
have the switch checked by an authorized electrician and replaced if necessary.
• Pull the power plug immediately after finishing work. Never leave the machine until you
have pulled the plug and secured the machine to prevent its unauthorized use .
CHANGING THE SAW BLADE
i
Pull the power plug!
• Allow the saw blade to cool and stop circling before you change it.
• Do not use inflammable liquids to clean the saw blade.
• Always wear gloves when handling saw blades.
1. Cut off the power.
2. Remove the blade cover slipknot (fig. 3A), the safety chain of rocker table (fig. 3B) , later
open forwardly the table cover carefully.
3. Fix the blade on the sawdust case with screws.
4. Release the screws with spanners carefully (fig. 4). Take much care, because sudden sliding
will hurt your hands seriously!
5. Remove the blade carefully, and replace it with a new one, the installing procedure is
opposite with the above one. Hold the blade firmly with your hands during replacement
and transportation. The blade is heavy and easy to slide.
TRANSPORT
• The wheels means that the saw can be transported by a single person.
• Fit the transit hook
To Next Page
Loading...