26 / 42
PL
SK
EN
CS
HU
STATUS INDICATOR (fig. 5A)
is normally lit continuously. In the event of problems, this light will start ‘flashing’ service codes
at different frequencies. You can find their meaning in the section Error codes.
ENERGY SAVER
• The wheelchair is equipped with an energy saving function. If you do not use the wheelchair
for more than 10 minutes, the power will turn off automatically (only the battery charge
indicator will remain functional). To turn on all circuits again, turn the main switch from
the ON position to the OFF position and turn it back to the ON position.
BATTERY STATUS POINTER INDICATOR (fig. 5B)
THE POINTER SHOWS THE BATTERY STATUS.
- the green field of the dial indicates sufficient charge
- the yellow field indicates that the battery needs to be charged
- the red field indicates the immediate need to shut down the machine and the need to
recharge the battery
Note: I
It is normal for the status indicator to temporarily drop sharply as the wheelchair
climbs a slope.
SPEED LIMITER KNOB (fig. 5C)
• controls the maximum achievable wheelchair speed
• Turn the knob counterclockwise to the minimum (turtle symbol)
• Turning the knob clockwise from minimum (turtle symbol) to maximum (rabbit symbol)
continuously increases the maximum achievable speed.
CONTROL LEVER (fig. 6A)
• Use this lever to start the machine
- set the speed control to minimum
- place both hands on the handles
- Slowly push the control lever to the right handle. The wheelchair starts to move forward.
- The more you press the lever against the handle, the higher the speed and vice versa.
- When the control lever is released, the wheelchair starts to brake automatically.
- The wheelchair starts to move backwards after releasing the right side of the control
lever, stopping and pushing the left half of the lever against the left handle.
C MAKE SURE YOU ARE NOT PRESSING BOTH PARTS OF THE CONTROL LEVER AT THE
SAME TIME. It may be damaged.
HORN (fig. 7A)
is controlled by pressing the button
HEADLIGHT (fig. 7C)
- is turned on by pressing the button
- turn it off by pressing the button again
TURN INDICATOR SWITCH (fig. 7B)
- use the switch to choose between left/right turn indicator. Middle position = off
To Next Page
Loading...