Safety instructions
1
Wallbox Energy Control safety instructions
1.1 Note to the owner and operator of the charging system
● Read
the operating manual before starting up the
charging system.
● Ensure that all persons working on or using this
charging system
○ have read the operating manual,
○ follow the regulations and instructions for
working without risk.
● Keep the equipment documentation at a location
where it is always accessible to the operators of
the charging system.
● Ensure that no unauthorized persons can access
the charging system.
1.2 Intended use
The charging system is intended for use in private and
semiprivate areas, e.g. private properties, corporate
parking areas, or depots.
Do not use the charging system where explosive or
combustible substances (e.g. gases, liquids, or dusts)
are stored or are present.
The charging system is intended exclusively for charg‐
ing electric vehicles.
● Charging in accordance with type 3 of IEC
61851-1
● Plug-and-socket connectors in accordance with
IEC 62196
● The charging system is intended for use only in
TT, TN-C, and TN-C-S networks. The charging
system must not be operated in IT networks.
The charging system is not suitable for charging vehi‐
cles with outgassing batteries (e.g. lead-acid batter‐
ies).
The charging system is intended exclusively for sta‐
tionary installation.
The charging system may only be operated and used
by persons who have read the operating manual.
The electrical installation, start-up, and maintenance
of the charging system may only be performed by
qualified electricians who have been correspondingly
authorized by the operator.
The qualified electricians must have read and under‐
stood the equipment documentation and must comply
with its instructions.
Requirements regarding the qualification of electri‐
cians
Knowledge of and compliance with the 5 safety rules
for working with electrical installations:
WB.000.3002-000UTKENU_02
Safety instructions
00.999.3046/ A.1.1
To Next Page
Loading...
