30
Additional modules
Overview
The additional modules are directly connected to the HSCI control
system through a slot on the MC main computer.
Module for analog
axes
Digital drive designs sometimes also require analog axes or
spindles. The additional module CMA-H 04-04-00 (Controller
Module Analog—HSCI) makes it possible to integrate analog servo
drives in an HSCI system.
The CMA-H is connected to the HSCI control system through
a slot on the underside of the CC or UEC. Every controller unit
has slots for two boards. The CMA-H does not increase the total
number of available axes: every analog axis used reduces the
number of available digital control loops by one. Analog control
loops also need to be enabled on the SIK. The analog control-loop
outputs can only be accessed via the NC, not via the PLC.
Additional module for analog axes/spindles
•
Expansion board for CC 61xx or UEC controller units
•
4 analog outputs, ± 10 V for axes/spindle
•
Spring-type plug-in terminals
CMA-H 04-04-00 ID 688721-xx
CMA-H 04-04-00
Field bus systems
An expansion board can be used to provide the MANUALplus
620 with a PROFIBUS or PROFINET interface at any time. This
makes the connection to an appropriate fieldbus system as master
possible.
PROFIBUS-DP
module
The PROFIBUS module is integrated in the control system by
using a slot in the MC. The interface is configured with IOconfig.
Additional module for PROFIBUS-DP
•
Expansion board for the MC main computer
•
Connection for D-sub connector (female) 9-pin to X121
PROFIBUS-DP additional module ID 828539-xx
PROFIBUS-DP module
PROFINET-IO
module
The PROFINET module is integrated in the control system
by using a slot in the MC. As of version 3.0, the interface is
configured with IOconfig.
Additional module for PROFIBUS-DP
•
Expansion board for the MC main computer
•
RJ45 connection at X621 and X622
PROFINET-IO additional module ID 828541-xx
PROFINET-IO module
To Next Page
Loading...
