Heinner HWM-6120 - EXCESSIVE FOAM IS FORMED IN THE DETERGENT DRAWER; UNSATISFACTORY WASHING RESULT

FAULT POSSIBLE CAUSE TROUBLESHOOTING
Excessive
foam is formed
in the detergent
drawer.
Excessive amount
of detergent used.
Press on Start/Pause
button. To eliminate foam
formation, mix a spoon
of softener with half
litres of water, and pour
the mixture in the detergent
drawer. After 5-10
minutes, press on Start/
Pause button again. In
your next washing operation,
Adjust the detergent
dose accordingly.
Wrong detergent
used.
Use detergents
produced only for
automatic washing
machines in your
machine.
Unsatisfactory
washing result.
The contamination degree
of your laundries
does not match the
programme you have
chosen.
Select the programme
appropriate for the
contamination degree
of your laundries. (See
programme table)
Amount of detergent
used insufficient.
Adjust the amount of
detergent based on the
amount and contamination
degree of your
laundries.
Laundries in excess
of maximum
capacity put in your
machine.
Load your machine with
laundries, amount of
which will not exceed
maximum laundry capacity.
www.heinner.com
64/74