WATER INLET HOSE CONNECTION
• Your machine may have either a single inlet (cold) or double water inlets (cold/hot)
based on its specifications. White-capped hose should be connected to cold water inlet
and red-capped hose to hot water inlet (applicable for machines with double water
inlets).
• Mount new water inlet hoses to a ¾ ˝, threaded faucet.
• If the water inlet hose is not already installed, it must be screwed to the appliance The
blue marked hose is only for cold water. Depending on the model, the hot water hose
marked with red should also be connected, for models having dual inlets. Screw by
hand the inlet hose onto the tap, tightening the nut.
• Flow of water with pressure of 0,1-1 Mpa will allow your machine to operate more
efficiently.) (0,1 Mpa pressure means that more than 8 litres of water will flow through
a fully-tapped faucet per one minute.)
• Ensure that points of contact do not leak by tapping the faucet completely after
carrying making the connections.
• Ensure that the new water inlet hoses are not bent, broken, crushed and resized.
• Fix the inlet hose to the cold water tap and to the inlet valve on the rear side of the
machine.
Note: Use only the new water inlet hose coming with your machine while making
water inlet connections of your machine. Never use old, used or damaged water
inlet hoses.
To Next Page
Loading...
Need help?
General
