www.heinner.com 6Kg, 220-240V~50Hz, 1000rpm
10
WATER DISCHARGE CONNECTION
• Never attempt to extend the water discharge hose by jointing.
• Do not put discharging hose of your machine in a vessel, bucket.
• Make sure that the water discharge hose does not bend, buckle, be crushed or
extended.
• Connect the drain hose to the drain or hook it over the edge of a sink by means of
the "U" bend.
• Fit the “U” bend D, if not already installed, at the end of the drain hose.
• If the washing machine is connected to an integrated drainage system, ensure that
the latter is equiped with a vent to avoid simultaneous loading and draining of
water (siphoning effect).
• Ensure that there are no kinks in the drain hose. Secure the hose so that it cannot
fall down. After wash phase, machine will drain out hot water.
• Small hand basins are not suitable.
• Fix the drain hose securely to prevent scalding during machine drainage.
To Next Page
Loading...
