If fault code "F14" is shown
Door open fault.
Action: Press "Start/Pause" button. The washing machine will try to open the door. The
alarm will not be removed until the door is unlocked. Or, turn the nub to Off for 3 seconds
to turn off the machine. Choose the desired programme to start the machine. The alarm
will be removed.
If fault code "F24" is shown
Water level reaches overflow level.
Remove it by pressing "Start/Pause" key and feed water.
Select and start required program. If fault occurs again, disconnect power supply and
contact the authorized service.
If else fault code "F04" , "F05", "F06", "F07", "F23" is shown
Electronic module fails
Turn the nub to Off for 3 seconds to turn off the machine.
After fault is removed, press "Start/Pause" key. If fault occurs again, disconnect power
supply and contact the authorized service.
If fault code “Unb” is shown
Unbalance alarm shall be solved by the following methods
1. Laundry winding
Turn the knob to "off" for 3 seconds for shutdown, open the door, shake the clothes and
put them back into the washing machine, then select the single dewatering program to dry
again.
2. Too light-weighted laundry
Turn the knob to "off" for 3 seconds for shutdown, open the door, put in one or two
towels, and then select the single dewatering program to dry again.
Before contacting the authorized service
1. Try to remedy the problem yourself (see Troubleshooting)
2. Restart the programme to check whether the problem has solved itself.
3. If the washing machine continues to function incorrectly, call the authorized service.
To Next Page
Loading...
Need help?
General
