61
configured with this)
◆Clock setup: Through this parameter, the meter time can be set to the actual time.
However, this time can be reset after the constant power failure of the meter.
◆Hourmeter reset to zero: This parameter can reset the hourmeter, hourmeter can
only be the accumulated working time of the instrument; (to configure this parameter,
enter the correct password first)
◆Percentage of liquid crystal contrast: the contrast can be adjusted by this
parameter (this parameter cannot be adjusted to 0 or 100%); (to configure this parameter,
enter the correct password first)
◆Percentage of pump power forbidden: when the meter shows the power through
this parameter, the pump lift and tilt are forbidden to work; (to configure this parameter,
enter the correct password first)
◆Password input: enter the password here. It is necessary to enter the password
again before parameter setting to modify the parameters. (default password: 000001)
◆New password: the password can be modified by this parameter after entering the
password;
◆Drive motor controller monitoring: under this menu, monitor the status of the
walking controller;
◆Pump motor controller monitoring: under this menu monitor pump controller
status.
4.2.4 ZAPI instrument
4.2.4.1 Panel position
To Next Page
Loading...
