HELI CQDH13 - Parking Vehicles Safely; Maintenance and Repair; Operation Safety and Environmental Protection

13
 Release the operating handle and the handle will automatically move to the upper
braking area (B).
 The pallet truck will brake until stop.
4.4.2 Inversion braking
 The truck brakes regeneratively when rotating the travelling switch ,until it starts to
move in the opposite direction.
4.4.3 Regenerative braking
 When the travel switch is set to the zero position , the truck brakes to a halt
regeneratively via the coasting brake.
 The mechanical brake applies below 1 km/h.
4.5 Parking vehicles safely
Note: No parking on slopes!
 Unload the goods on the platform.
 Press the emergency stop switch.
 Turn the key to the "OFF" position and pull out the key.
5. Maintenance and repair
5.1 Operation safety and environmental protection

The inspection and maintenance operations described in this chapter must be performed
according to the time limit listed on the maintenance checklist.

Modifications to vehicles, especially safety devices, are prohibited. The working speed of the
vehicle must not be changed.

Only the original parts can meet the quality management requirements of the company. In
order to ensure the stable and reliable operation performance of the equipment, only the
original spare parts produced by our company can be used. Aging components and
replacement liquid media must be treated in accordance with current environmental
regulations. If you need to change the oil, you can contact our customer service department.

After the inspection and maintenance operation is completed, the operation steps specified
in the "re-commissioning" section must be followed.