Helite e-Turtle 2 - Certifications

22
English
1. CERTIFICATIONS
The product TURTLE II ELECTRONIC (e-Turtle 2) is CE certied by ALIENOR CERTIFI-
CATION (Zone du Sanital, 21 Rue Albert Einstein CHATELLERAULT-France) notied
body n° 2754 following the CRITT-SL protocol n° AMC-012 : 02/2020. This product
complies with the requirements of the EU regulation 2016/425. The EU declaration
of conformity can be consulted on the helite.com website.
The CDU electronic card is certied IEC 62368-1 / EN-62368-1 / UL62368-1 /
CSA62368-1 by TÜV Rheinland (Tillystr. 2, 90431 Nürnberg, Germany) notied body
no. 0197.
Helite declares that the CDU electronic card complies with the essential requi-
rements and other relevant provisions of the RED (Radio Equipment Directive)
2014/53/EU and RoHS 2011/65/EU.
ISED Statement:
For general products, this device contains licence-exempt transmitter(s) that com-
ply with Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two conditions:
(1) this device may not cause interference ;
(2) this device must accept any interference, including interference that may cause
undesired operation of the device.
FCC Statement:
For general product, this device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) This device may not cause harmful interference;
(2) this device must accept any interference received, including interference that
may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are de-
signed to provide reasonable protection against harmful interference in a residen-
tial installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment o and on, the user is encou-
raged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit dierent from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Changes or modications not expressly approved by the party responsible for com-
pliance could void the user’s authority to operate the equipment.