37
Battery is charged
The LED turns green +
no beep.
Unplug the charger, you can
use the airbag vest.
With SDU fork sensor option
Pairing in progress
The LED turns blue + 1 beep
every 5 s. during 30 s.
You have 30 s. to place the
magnet over the SDU fork
sensor.
With SDU fork sensor option
Pairing successful
The LED turns blue + 1 long
beep for 2 s.
The airbag vest and the SDU
fork sensor are now paired.
With SDU fork sensor option
Pairing active
The LED turns blue + 2 beeps.
The airbag vest and the SDU
fork sensor are correctly
paired.
With SDU fork sensor option
Pairing failed
The LED turns red + 4 beeps.
Repeat the pairing procedure
or delete all the SDU fork
sensors already paired.
Airbag not working
The LED ashes red +
series of beeps.
ATTENTION, a problem has
occurred.
- Cartridge disconnected:
connect the cartridge.
- Empty cartridge, damaged
cable: replace with a new
cartridge.
- Other cases: please contact
the customer service.
9) SERVICING AND MAINTENANCE
a) Washing the airbag vest
Please follow these instructions to avoid damage to the aibag and the electronic
system. Do not machine wash, do not immerse in water or dry clean. The only
way to clean the airbag vest is with a soft cloth slightly soaked in soap. Do not use
detergents or bleach. Do not put in the dryer or on a radiator. Do not iron. We re-
commend that you dry them on a hanger in a dry place.
b) Annual e-cartridge check
We recommend an annual check of the weight and condition of the cartridge. The
airbag vest must be switched o. Unplug the cartridge and unscrew it. Weigh the
cartridge on an accurate kitchen scale. Make sure the weight of the cartridge is wit-
hin +/- 3 grams for e-60 cc and +/- 5 grams for e-100 cc of the weight indicated on
the cartridge label. Check the appearance of the cartridge: connector wire in good
condition, no corrosion, no dents. If nothing to report, reinstall the cartridge (see
To Next Page
Loading...
Need help?
General
