28
English
5. BEFORE FIRST USE
a) Pairing the SDU fork sensor with the airbag vest (optinal)
Before using the airbag vest for the rst time, you must pair it with the SDU fork
sensor. To complete the pairing procedure you will need the SDU fork sensor,
the magnet and the airbag vest. If you have lost the magnet you can use a similar
magnet (of the same type). If you have other airbag vests that are associated with
this SDU fork sensor they must be turned o.
GOOD TO KNOW
• Up to 5 SDU fork sensors can be paired to the airbag vest (i.e. if you have several
motorcycles). For each one, you will need to complete the pairing procedure.
• An unlimited number of airbag vests can be paired to a single SDU fork sensor.
x3
3
sec
3
1
2
1
Turn on the airbag vest by pressing the ON/OFF button
3 times quickly (see
page 31). A beep will sound and a green LED will ash.
2
Press and hold the ON/OFF button for 3 seconds, the LED will turn blue and a
beep will sound. Release the button and go to the next step.
3
Place the magnet on the SDU fork sensor over the round sign. Be careful, you
have 30 seconds for this operation.
• If you hear 1 long beep: the pairing was successful.
• If you hear 2 short beeps: the airbag vest and the SDU fork sensor are already
paired. No need to repeat the procedure.
• If the LED turns red and you hear a series of short beeps: the pairing has failed.
Either you have taken more than 30 seconds to place the magnet on the SDU fork
sensor. In this case please restart the pairing procedure. Or you have too many SDU
fork sensors paired (5 maximum). In this case you need to delete the SDU fork sen-
sors paired with the airbag vest. To delete all the SDU fork sensors paired with the
airbag vest, turn on the airbag vest and press the ON/OFF button
for 8 seconds.
CHECK THE PAIRING
We recommend that you check the pairing of the airbag vest to the SDU fork sensor
at least once a month. If you have lost the magnet, you can use a similar magnet
(of the same type).
To Next Page
Loading...
Need help?
General
