4-channel
3-channel
Caution: Channel C and D must be bridged in 3-channel mode operation, because channel A and B can only
be bridged in 2-channel mode. It ensures that channel C and D are used as mono channel for the subwoofer.
Only this channels have bassboost.
2-channel
Caution: Bridge at first channel C and D before you switch to 2-channel mode. If channel A and B cannot be
bridged make sure that switch 29 of channel C and D is set on position bridged “on”.
Full active operating mode
With the use of control 30 the amplifier is operating in full active mode.Set the switch 30 “Full Active Operating
Mode” to position “on” . The signal is always transmitted as lowpass to channel C and D.
Channel A
Channel B
Channel C
Channel D
Channel A
Channel B
Channel A and B bridged/ Mono
Channel C and D bridged/ Mono
Channel C and D bridged/ Mono
switch 29
switch 30
“Channel C/D bridged” on “on”
ENGLISH
To Next Page
Loading...
