Need help?Do you have a question about the HELIX M SIX and is the answer not in the manual?
General| Channels | 6 |
|---|---|
| Idle current | 1.5 A |
| Amplifier Class | D |
| Output power @ 4 Ohms | 6 x 100 Watts |
| Output power @ 2 Ohms | 6 x 150W |
| Bridged output power @ 4 Ohms | 3 x 300 Watts |
| Frequency response | 10 Hz - 30, 000 Hz |
| Signal-to-noise ratio | >100dB |
| Input impedance | 10 kOhms |
| Input sensitivity | 0.5V - 6V |
| Features | Start-Stop capability, High-level input |
Guidance on safely installing HELIX components, emphasizing manual reading and professional installation.
Instructions for wiring the amplifier to the vehicle's 12V negative terminal system and using appropriate fuses.
Connects audio sources via RCA and adjusts input sensitivity for optimal gain.
Adjusts highpass, lowpass, and subsonic filters for audio signal shaping.
Connection points for speaker systems, ensuring correct impedance.
Connects power (+12V), ground (GND), and remote turn-on signals (REM).
Explains the 6-channel low-level input and the input sensitivity adjustment.
Details the function and adjustment of HPF, LPF, and Subsonic/HPF filters.
Describes summing input signals and the LED indicator for amplifier status.
Using correct RCA cables to connect to head unit/car radio outputs.
Mandatory step to adapt M SIX sensitivity to signal source to avoid damage.
Connecting +12V and ground cables with proper gauge and fusing.
Connecting speakers directly, ensuring correct phasing and minimum impedance.
Wiring diagram for component, coaxial systems, and a 2x2 Ohm subwoofer.
Wiring diagram for component, coaxial systems, and a bridged 1x4 Ohm subwoofer.
RMS and max output power ratings for various impedance configurations.
Details frequency response range and adjustable crossover filter limits.
Highlights features like Start-Stop capability and adjustable crossovers.
To Next Page