Need help?Do you have a question about the HELIX B Five and is the answer not in the manual?
Install amplifier in a dry, well-ventilated area, secured professionally with four screws.
Connect only to 12V minus pole chassis ground. Use main fuse near battery and protect cables.
Overview of LED indicators, fuses, and essential cable connections for amplifier operation.
Details on connecting speakers to terminals and audio sources via RCA or highlevel inputs.
Configure signal input modes and set active crossover frequencies for various channels.
Adjust input sensitivity, bass boost levels, and channel level controls for optimal performance.
Detailed explanation of the Power/Protect LED and the function of the amplifier's fuses.
Step-by-step details for connecting ground, remote, and battery cables correctly.
Explanation of RCA and highlevel signal inputs, and the input signal mode switch.
Details on setting highpass or fullrange for channels 1 and 2, and adjusting frequency.
Guide to setting highpass, fullrange, or bandpass for channels 3/4 and adjusting frequencies.
Explanation of lowpass filter for channel 5 and adjustment of bass boost level.
Visual guides for connecting speakers in 5-channel, 3-channel bridged, and fully active modes.
Instructions for connecting speakers and setting crossovers for fully active mode.
Detailed technical data including output power, frequency response, and dimensions.
Information on limited warranty, exclusions, and conditions for service.
To Next Page
General
