Performing a reset / Menu point
By performing a reset you will restore the factory settings.
Please note: All settings you have made will be deleted!
In order to perform a reset follow these steps:
1. Scroll to the menu point
2. Press the function key ``GO/SET´´. ``Res´´ in the display starts to flash. If you want to
cancel, press ``ESCAPE´´.
3. Press the function key ``GO/SET´´ again. The display shows a ``y´´ to the left and
a ``n´´ to the right.
4. Confirm your choice by pressing the function key ``UP´´ for ``yes, performing a reset´´ or
``DOWN´´ for ``no / escape´´.
5. After having pressed the function key ``UP´´ for ``performing a reset´´ the display will return to the Res.
6. Finish by calibrating. See Section 6B.
Calibrating the bridge / menu point
The bridge will automatically calibrate itself, when travelling past the zero position during
normal operation. The zero position is where the sensor is located in the side of the pit.
However, there are times when you have to calibrate the bridge
(See section 5D `Menu of the control box´ for more information).
To calibrate, follow these instructions:
1. Scroll to the menu point .
2. Press the function key ``GO/SET´´. ``Cal´´ in the display starts to flash.
In case you want to cancel, press ``ESCAPE´´.
3. Press the function key ``GO/SET´´ again ``Cal´´ in the display flashes half as quick as before.
The bridge will start to turn first slow, then fast until it reaches ``0´´-position and then stop at the pre-installed
position 1.
Please note, If the bridge does not stop at position ``1´´ after calibration a counting error has
occurred and the bridge needs to be calibrated again.
Setting a programmed stop of the bridge / Menu point
1. Scroll to the menu point ``Prog´´.
2. Press the function key ``GO/SET´´. ``Prog´´ in the display starts to flash. In case you want to
cancel, press ``ESCAPE´´.
To Next Page
Loading...