Deleting a programmed stop of the bridge / Menu point
In order to delete a position of the bridge follow these steps:
1. Scroll to the menu point ``del´´
2. Press the function key ``GO/SET´´
3. Press the function key ``GO/SET´´ again. The display shows a ``d´´
and the number of your current stop. If you want to delete another stop than the chosen one, simply choose
another by pressing the “UP” or “DOWN” buttons. Please note that deleting a position causes all positions
above the deletion point to be decremented by one position number.
4. Delete the chosen stop by pressing the function key ``GO/SET´´ again.
All positions with a number higher than the deleted one are renumbered automatically.
Please note: After completion of deleting desired positions, the display always returns to show Tr 1.
7. Driving the bridge to a programmed stop / Menu point
In order to change the bridge’s position, follow these steps:
1. Scroll to the menu point ``tr´´. The digit no. shows the current position of the bridge.
2. Press the function key ``GO/SET´´. ``tr´´ in the display starts to flash.
In case you want to cancel, press ``ESCAPE´´.
Remark: In order to avoid involuntary changes of the bridge’s position by pressing the function
keys ``UP´´ or ``DOWN´´ by accident you need to press the function key ``GO/SET´´ first before
choosing a new position for the bridge. When just pressing the function keys ``UP´´ or ``DOWN´´
you will scroll from one menu point to another.
3. Press the function keys ``UP´´ or ``DOWN´´ to choose the number of the track position to go to. Only the
numbers of stops that have been programmed are shown.
4. Press the function key ``GO/SET´´ again. ``tr´´ in the display flashes half as fast as before
and the bridge will move to the next track position.
Please note: If the bridge is already at the selected position number and you’ve gone all the way to step 4, then
The bridge will do a 180 degree turn from its current position.
To Next Page
Loading...