Need help?Do you have a question about the Hello Bee Prusa DIY 3D PRINTER KIT and is the answer not in the manual?
General| Filament Diameter | 1.75 mm |
|---|---|
| Connectivity | USB, SD Card |
| Heated Bed | Yes |
| Bed Leveling | Manual |
| Technology | FDM (Fused Deposition Modeling) |
| Supported Materials | PLA, ABS |
| Nozzle Diameter | 0.4 mm |
| Software | Repetier-Host, Cura |
| Weight | 8kg |
Instructions for setting up the Cura slicing software with appropriate printer parameters.
Procedure for precisely leveling the print bed using the printer's LCD interface for optimal adhesion.
Steps to define the positional difference between dual extruders for accurate multi-material prints.
Procedure to ensure both extruders are at the same vertical level for consistent printing.
Workflow for preparing and executing prints using two extruders in slicing software.
Instructions for updating the printer's internal control software (firmware).
Utilizing the Pronterface software to perform the bed leveling process.
Guide for executing the initial print using the Pronterface control interface.
Alternative method for filament management via the printer's LCD menu.
To Next Page