3
FIRST PRINT
For our first print, we will be using the free 3DBenchy 3D model - you can download it here:
http://www.3dbenchy.com/
There are a few ways to print but we strongly recommended using Cura and an SDcard.
CONFIGURING CURA 15.04.6
In order to generate the G-code for printing, you can use the Cura 15.04.6
Please download only related versions from this link:
https://ultimaker.com/en/products/cura-software/list
Cura 15.04.6 screenshot
To Next Page
Loading...