10
USE THE FOLLOWING COMMANDS FOR END2.GCODE:
;End GCode
M104 T0 S0 ;extruder heater off
M104 T1 S0 ;extruder heater off
M140 S0 ;heated bed heater off (if you have it)
G91 ;relative positioning
G1 E-1 F300 ;retract the filament a bit before lifting the nozzle, to release some of the pressure
G1 Z+0.3 E-5 F{travel_speed} ;move Z up a bit and retract filament even more
G28 X0 Y0 ;move X/Y to min endstops, so the head is out of the way
G90 ;absolute positioning
G1 Y180
M84 ;steppers off
;{profile_string}
Before start printing, you just need to confirm that your machine is correctly configured and with
the latest firmware.
To Next Page
Loading...