14
Now, you use the 3 screws to level the bed. Remember that you need to keep the same clearance
from the nozzle on all points of the bed.
Next step is to adjust the home Z axis so the nozzle can stay at a distance of about 0.2mm from the bed.
You can use a sheet of paper as reference for the needed distance.
Example of the nozzle staying at about 0.2mm from the bed:
Make sure the clearance between the nozzle and the build plate is the same near the three
calibration screws. If you find that the calibration is not satisfactory, repeat the process and check
the clearance on all three points again.
To Next Page
Loading...