Helmer PC4200i - Page 2

Document Updates
The document is furnished for information use only, is subject to change without notice and should not be construed as a commitment
by Helmer Scientic. Helmer Scientic assumes no responsibility or liability for any errors or inaccuracies that may appear in the
informational content contained in this material. For the purpose of clarity, Helmer Scientic considers only the most recent revision of
this document to be valid.
Notices and Disclaimers
Condential / Proprietary Notices
Use of any portion(s) of this document to copy, translate, disassemble or decompile, or create or attempt to create by reverse
engineering or otherwise the information from Helmer Scientic products is expressly prohibited.
Copyright and Trademark
Helmer
®
, i.Series
®
, i.Center
®
, Horizon Series™, AgiTrak™, and Rel.i™ are registered trademarks or trademarks of Helmer, Inc. in
the United States of America. Copyright © 2017 Helmer, Inc. All other trademarks and registered trademarks are the property of their
respective owners.
Helmer, Inc., doing business as (DBA) Helmer Scientic and Helmer.
Disclaimer
This manual is intended as a guide to provide the operator with necessary instructions on the proper use and maintenance of certain
Helmer Scientic products.
Any failure to follow the instructions as described could result in impaired product function, injury to the operator or others, or void
applicable product warranties. Helmer Scientic accepts no responsibility for liability resulting from improper use or maintenance of its
products.
The screenshots and component images appearing in this guide are provided for illustrative purposes only, and may vary slightly from
the actual software screens and/or product components.
Helmer Scientic
14400 Bergen Boulevard
Noblesville, IN 46060 USA
www.helmerinc.com
ISO 13485:2003 CERTIFIED Part No. 360096-1/ Rev P
Document History
Revision Date CO Supersession Revision Description
I 28 JUN 2013 8414
Supersedes A, B, C,
D, E, F, G, H
Revised layout for ease of navigation and locating information.
J 23 DEC 2013 8965 J supersedes I
Added 100 V information.
Added caution note for remote alarm interface.
Revised section I for consistency with existing manuals.
K 31 JAN 2014 9113 K supersedes J Changed voltage for remote alarm contacts.
L 22 APR 2014* 9386 L supersedes K Revised voltage specication for remote alarm contacts.
M 26 MAY 2014* 9497 M supersedes L
Added 0086 to CE certication.
Revised caption under photograph (chapter 16.1).
Revised power failure alarm test (chapter 19.2).
N 21 SEP 2015* 9754 N supersedes M
Changed part number for terminal board (chapters 12 and 21)
Revised schematic to correct labeling of J1 and J3 on the display board (page
78).
Changed test procedure for No Battery alarm test (chapter 8.8.7).
O 12 JUL 2016 12016 O supersedes N Updated Power Failure test for Horizon units
P 6 DEC 2017 13171 P supersedes O
Reformatted content. Updated Emergo address. Updated condensing unit and
refrigerant charge information for PC2200, PC3200 and PC4200, 115 V and 230 V
models.
* Date submitted for Change Order review. Actual release date may vary.