19
Settings are made in the Set-Up/Settings menu. Use the left button to conrm/accept input
and move backwards. Use the right button to conrm/accept input and move forward. The
center button scrolls up/downwards and ticks boxes.
1. Turn on the analyzer as described in the Start-Up section.
2. Press the right button.
3. Press right button to chose menu and move to next window.
4. Enter PIN Code window is shown. The Pin Code is used to prevent unauthorized users
from entering/changing input in the settings menu. As default, the PIN Code is set to
0000. For change of PIN Code see step 19, Settings section.
Enter the PIN code by pressing the center button to change digit. Press right button to
confirm the input and move to the next. After entering the four digit PIN Code press
right button to accept and move to next window.
5. If the analyzer is configured for USB - window 5a is shown. If the analyzer is config-
ured for ethernet - window 5b is shown. The display shows: Home, Review/Delete and
Settings. Press the right button to enter Settings.
To Next Page
Loading...
Need help?
General
