27
1. Connect the cable* to the analyzer and ASCII printer* before performing the analysis.
Perform the analysis as described in the Routine Use Patient Test or Routine Use QC
Test sections.
2. The result is shown on the display (2a) and will be printed automatically (2b).
Only current result can be transferred directly to the printer. Stored results can not be
printed.
*Must be purchased separately.
Read and follow the printer instructions for use to adjust the following COM-port settings.
• Baud rate 9600
• Databits 8
• Parity None
• Stopbits 1
• Flow control None
To Next Page
Loading...
