Why is the material from my Henkel Loctite partially unmixed?
If you're getting partially unmixed material through the cycle of your Henkel Dispenser, the mixer may not be clean or free. Dismantle and clean or replace it.
Why is material leaking past inlet valves of Henkel Loctite?
If material leaks past the inlet valves of the dispense valve, dispense block, or mixing block in your Henkel Dispenser, it's likely that the inlet valve O-rings or seals are damaged or worn. Replace the O-rings or seals.
Warranty terms for seller-manufactured parts and components.
Warranty terms for third-party equipment and components.
Overview of the machine's logic-based controls and functions.
Details on additional functional components of the machine.
Daily maintenance procedures for the machine's components.
Weekly maintenance procedures for the machine's components.
Addresses pumping problems after initial system startup.
Troubleshooting pneumatic system problems post-startup.
Troubleshooting issues related to the motionless mixer.
Guidance on operating and maintaining the desiccant air dryer.
To Next Page
General
