Henny Penny 600 User Manual (English)

Other manuals for Henny Penny 600

Service Manual270 pages

User Manual43 pages

Technical Manual236 pages

Questions and Answers:

D
Dalton ShawSep 2, 2025
What to do if Henny Penny 600 Fryer product is not done?
- H
  Heather GarciaSep 2, 2025
  If the product from your Henny Penny fryer is not done, it might be due to a few reasons. Ensure you are using fresh or thawed product, not frozen. Also, verify that the correct product button is selected. Check if the temperature is programmed too low or not programmed properly. Also, the temperature probe might be out of calibration. Make sure that the product is not too thick. Avoid aborting the cook cycle before the alarm sounds and the 'DONE' light flashes. If the fryer heat-up/recovery is slow, there might be an issue with the heating elements.
S
Sharon TorresAug 31, 2025
What to do if my Henny Penny Fryer condensation line is clogged?
- Q
  qtaylorAug 31, 2025
  Remove and clean the condensation line.
R
Richard MartinezAug 30, 2025
What to do if my Henny Penny 600 pressure does not build?
- B
  Becky Singh PhDAug 30, 2025
  If the pressure does not build, place a full capacity of product in the frypot when using fresh shortening. There may not be enough product in the frypot.
A
Austin DavisAug 29, 2025
What to do if my Henny Penny 600 Fryer is showing error “E-15” Drain valve open?
- Q
  qjonesAug 29, 2025
  Close the drain valve.
A
Alicia AllenAug 27, 2025
Why is my Henny Penny 600 shortening not heating?
- W
  Willie CunninghamAug 27, 2025
  If the shortening is not heating, make sure the gas control valve knob is turned to the on position. The gas valve knob may be in the off position.
P
Paul RobertsonAug 27, 2025
Why won't my Henny Penny 600 heat up?
- L
  Luke CarpenterAug 27, 2025
  If the peanut oil in your Henny Penny fryer isn't heating up, start by checking the obvious: ensure the fryer is plugged in and the circuit breaker hasn't tripped, or the fuse blown. For gas models, confirm the gas valve knob is in the ON position. If those aren't the issue, inspect the cord and plug for any damage. Other potential causes include a faulty PC board, a tripped high limit, an open drain valve, a faulty temperature probe or contactor (for electric models), or a faulty thermocouple on the gas control valve (for gas models). Also, the COOK/PUMP switch might be faulty. If the high limit is tripped, try resetting it. Make sure the drain valve is closed.
B
Brett HerreraAug 25, 2025
What to do if my Henny Penny Fryer is not draining shortening?
- A
  Ashley SmithAug 26, 2025
  If the shortening is not draining, push a cleaning rod through the open drain valve. The drain valve may be clogged.
M
Melanie MillerAug 23, 2025
What to do if my Henny Penny Fryer shows “E-5” “OIL TOO HOT”?
- M
  mary77Aug 23, 2025
  If the display shows “E-5”, the shortening is overheating. Turn the switch to the off position, then turn the switch back to on. This relates to the heating circuits.