What to do if my Henny Penny 500 shows “E-4” “CPU TOO HOT”?
If the display shows “E-4”, the control board is getting too hot. First, turn the switch to the off position, then turn it back on. Check the louvers on each side of the unit for obstructions and inspect the cooling fan, if your fryer has one.
What to do if my Henny Penny 500 Fryer shows “E-5” “OIL TOO HOT”?
If the display shows “E-5”, the shortening is overheating. Turn the switch to the off position, then turn the switch back to on. This relates to the heating circuits.
What to do if my Henny Penny 500 Fryer is not draining shortening?
If the shortening is not draining, push a cleaning rod through the open drain valve. The drain valve may be clogged.
Why is my Henny Penny 500 shortening not heating?
If the shortening is not heating, make sure the gas control valve knob is turned to the on position. The gas valve knob may be in the off position.
What to do if my Henny Penny Fryer is showing error “E-15” Drain valve open?
Close the drain valve.
What to do if my Henny Penny 500 Fryer pressure does not build?
If the pressure does not build, place a full capacity of product in the frypot when using fresh shortening. There may not be enough product in the frypot.
What to do if my Henny Penny 500 condensation line is clogged?
Remove and clean the condensation line.
What to do if my Henny Penny Fryer pressure does not exhaust at end of cook cycle?
If the pressure is not exhausting, turn off the fryer and allow it to cool to release the pressure in the frypot. Have all lines, the solenoid, and the exhaust tank cleaned, as the solenoid or exhaust line may be clogged.
What to do if my Henny Penny Fryer filter motor will not run?
If the filter motor will not run, reset the motor, as it may have overheated.
What to do if my Henny Penny Fryer operating pressure is too high?
If the operating pressure is too high, turn off the fryer and allow it to cool to release the pressure in the frypot. Clean the deadweight, as it may be clogged.
Description, checkout, and replacement of the high temperature limit safety control.
Description, checkout, and replacement procedures for heating elements.
Description, checkout, and replacement of primary and heat contactors.
Covers solenoid valve, deadweight valve, safety relief valve, and pressure gauge.
Information on filter rinse hose, valve, pump repair, and cover/pump removal.
Location and reference to wiring diagrams for various models.
Illustrates components and lists associated part numbers and quantities.
Calibrates amp sensors to monitor heating element current.
Wiring diagram for a specific model and configuration.
Wiring diagram for a specific model and configuration.
Wiring diagram for a specific model and configuration.
Wiring diagram for a specific model and configuration.
Inspects plumbing for cleanliness and blockages, checks for leaks.
Visually inspects the high limit probe bulb and capillary tube for damage.
General| Brand | Henny Penny |
|---|---|
| Model | 500 |
| Category | Fryer |
| Language | English |
To Next Page
