What to do if Henny Penny EVOLUTION ELITE EEG-244 displays error E-4?
If your Henny Penny Fryer displays error code “E-4”, the control board is overheating. First, turn the switch to the off position, and then turn it back on. If the display continues to show “E-4”, check the louvers on each side of the unit for any obstructions.
What to do if Henny Penny EVOLUTION ELITE EEG-244 displays error E-20-B?
If your Henny Penny Fryer displays error code “E-20-B”, it could be due to a pressure switch failure or a loose hose, or it could be a draft fan failure or low voltage. Press the power button to turn the vat off and then back on again. If the error persists, have the pressure switch checked to ensure it is an open circuit when there is no air pressure, and make sure the hose is connected to the fan and pressure switch. Also, have the draft fan checked for low voltage.
What to do if Henny Penny EVOLUTION ELITE EEG-244 Fryer displays error code E-10?
If your Henny Penny Fryer displays the error code “E-10”, it indicates a high limit issue. Allow the unit to cool down for about 15-20 minutes. Then, push up on the metal reset button located under the right side of the controls. If the high limit still doesn’t reset, the high limit component needs to be replaced.
What to do if Henny Penny EVOLUTION ELITE EEG-244 Fryer power switch is ON but the fryer is completely inoperative?
If your Henny Penny Fryer's power switch is ON but the fryer isn't working, it could be due to an open circuit. First, ensure the fryer is properly plugged in. If it is, check the breaker or fuse at the supply box.
What to do if my Henny Penny EVOLUTION ELITE EEG-244 is under-filled?
If the vat in your Henny Penny Fryer is under-filled, it could be due to several reasons: - The JIB might be low or empty, so you should fill the JIB. - The JIB oil line might be clogged or collapsed, so check the JIB line. - The filter pan might need cleaning, so clean the filter pan and change the paper or pad.
What to do if my Henny Penny EVOLUTION ELITE EEG-244 Fryer filter motor will not run?
If the filter motor on your Henny Penny Fryer won’t run, the thermal reset button on the rear of the pump motor may be tripped. First, turn the unit’s power switch to the OFF position to prevent burns from splashing shortening. Allow the motor to cool down. Then, using a screwdriver, press hard against the button until you hear a click.
General| Manufacturer | Henny Penny |
|---|---|
| Model | EVOLUTION ELITE EEG-244 |
| Fryer Type | Electric |
| Voltage | 208-240 V |
| Phase | 3 |
| Type | Fryer |
To Next Page
