user manual INTEGRA
HENSEL Studiotechnik 10
Tilting Head 15:
Positioning
INTEGRA compact flash units are equipped with a Tilting Head
15. The unit can be attached to a stand or pantographs using
one of the two holes a. The head can be swivelled round 360°.
By tightening the knurl screw b the unit can be fixed. The safety
screw must be screwed into thread c. Wing nut d guarantees
for tilting up and down. To ensure smooth movement please oil
the threat if necessary. Above the tillting head an umbrella
holder e is integrated.
Accessories
All HENSEL reflectors and HENSEL softboxes of series EHT
(adapter Ø: 10 cm), accessories included, may be attached to
the INTEGRA compact flash; also umbrellas and Softstar.
Assembly of reflectors and softboxes
For fixing reflectors or softboxes to the compact flash unit,
please first of all open the holding clamps. For doing this,
please tension lever 14 laterally as far as it will go against the
spring tension. While doing this, the holding clamps will open.
Now even and precisely attach the accessory part to the unit.
Please do not tilt. By releasing the lever, the holding clamps
will completely enclose the accessory part.
For loosening the accessory, please hold tight the accessory
part (Attention - it could be hot!) and tension lever 14 again as
described above.
In any case please make sure not to damage either the
flashtube or the modeling lamp (danger!).
Assembly of umbrellas and Softstar
An umbrella holder is integrated above the tilting head 15. It
allows for the connection of various umbrellas by using a strong
gripping spring mechanism.
No screw is required, which could cause damage to the
umbrella.
Fixing of the glass dome
Attention
:
The glass dome should only be fixed or removed after having
switched off the unit and unplugged from the mains outlet.
Please take care not to damage either the flashtube or the
modeling lamp (danger!).
The glass dome is fixed by means of the three pre-mounted
springs. For doing this, please slightly tilt the glass dome and
insert it into one of the three springs. Then press the glass
dome gently into the other two springs until it has completely
clicked in.
To Next Page
Loading...