user manual INTEGRA
HENSEL Studiotechnik 6
• Ventilation slots of compact flashes must be kept free during
operation and sufficient air supply must be ensured. Do not
stick any objects into ventilation slots or synchronization
sockets.
Do not deposit any objects (tools, coffee cups, etc.) on the
flash unit.
• Flash systems must not be used in environments with
explosion hazard. Flammable materials, like furnishing
fabrics, paper, etc. must not be stored in the immediate
vicinity of compact flash units to prevent fire hazards.
• Compact flash units must be protected against humidity and
spray water.
• Do not connect accessories from other manufacturers, even if
they use the same or similar connectors.
• Flash units - hanging from pantographs or ceiling - must be
doubly secured against falling down.
• Do not flash into eyes at short distances (smaller than 5 m),
because this can lead to eye damage. Do not look directly into
the flash reflector, the flash lamp could be triggered
inadvertently.
• Regularly air closed rooms to prevent build-up of inadmissible
ozone concentrations, which can occur due to the use of high-
powered flash systems.
• During work in the studio generating much dust, the appliance
must be covered with suitable dust protection (not during
operation).
4 Standard delivery
INTEGRA 250/500 Bi-Voltage is equipped with a sliding switch
which allows either 230V or 115V operation. The units are
supplied with:
• Flashtube, single coated, user replaceable
• Protection glass dome, clear, uncoated
• Tilting Head with integrated umbrella holder
• Cableset: Power and Sync. cord
To Next Page
Loading...
