Page 10 For technical questions, please call 1-888-866-5797. Item 59313
MAINTENANCE AND SERVICING
Procedures not specifically explained
in this manual must be performed
only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM
ACCIDENTAL OPERATION:
Turn the Power Switch of the tool off and unplug the
tool from its electrical outlet before performing any
procedure in this section.
TO PREVENT SERIOUS INJURY FROM TOOL
FAILURE:
Do not use damaged equipment.
If abnormal noise or vibration occurs, have
the problem corrected before further use.
Cleaning, Maintenance,
and Lubrication
1. BEFORE EACH USE, inspect the general
condition of the tool. Check for:
• loose hardware,
• misalignment or binding of moving parts,
• cracked or broken parts,
• damaged electrical wiring, and
• any other condition that may
affect its safe operation.
2. PERIODICALLY, wear ANSI-approved safety goggles
and NIOSH-approved breathing protection and blow
dust out of the motor vents using dry compressed air.
3.
WARNING! TO PREVENT SERIOUS
INJURY: If the supply cord of this power
tool is damaged, it must be replaced only
by a qualified service technician.
4. After Use:
a. Wear ANSI-approved safety goggles and
NIOSH-approved breathing protection, blow
debris from Planer using dry compressed air.
b. Remove resin residue with pitch and gum remover.
c. Empty dust collection system.
d. Wipe external surfaces with clean cloth.
e. Wax tables.
Internal Maintenance
1. Remove the two Screws on Side Cover.
2. Lift up and tilt bottom out to remove Side Cover.
Side
Cover
Lubrication
3. Elevation Screws and Columns
a. Remove both Side Covers.
b. Clean Elevation Screws and Columns.
c. Lubricate with a light coating of
multipurpose grease (sold separately).
4. Roller Chains
a. Remove left Side Cover.
b. Use chain cleaner (sold separately)
according to manufacturers instructions.
c. Lubricate with chain oil (sold separately),
wipe off excess oil.
To Next Page
Loading...