034-11471_1.1_11.10.2017
101
Maintenance
8.4.5 Offsetting brake lining wear
8.4.5.1 Hydraulically operated rim brake
(Alternative equipment)
The setting bolt on the brake lever of the hydraulic rim
brake is used to offset the brake lining wear. If the
profile of the brake pads has a remaining depth of only
1 mm, the brake pads will need to be replaced.
In order to reduce the free travel and offset the
brake lining wear, screw the setting bolt in.
To increase the free travel, screw the setting bolt
out.
With the optimum setting the action point, i.e. the
point at which the brake takes effect, is reached
after 10 mm of empty travel.
Figure 35: Brake lever (1) of the hydraulically operated rim brake with setting
bolt (2)
EN_034-11471_1.1_0.01_09.18_HERCULES BOSCH_Puria_Inhalt.book Page 101 Wednesday, October 11, 2017 1:59 PM
To Next Page
Loading...