12/18 13/18
4.4 Adjust the volume level on your headphones using the Vol -/+ knob.
4.5 Start playing the track to be previewed on deck B. Prepare the track (beatmatch the
track, place a Cue point...).
Mixing tracks means to link up songs,
one after another, without any gaps or
silences between them.
5.5 Before the end of the track being
played, start playing the track loaded
on deck B.
5.7 To make the transition, progressively
move the crossfader toward the deck
on which the new track is being played
(here, to the right).
5.6 To ensure a transition at the same
tempo, synchronize the BPM (number
of beats per minute) of the track that
you are getting ready to play. Adjust
the BPM to match the BPM of the track
on deck A using the pitch (tempo) fader
(1). Or press the
button on deck
B (2) to synchronize the track’s BPM
with the BPM value of the track that is
ending (on deck A).
5.1 You have loaded a track on each deck
(A and B). Position the volume faders as
shown below.
5.4 Select previewing on deck B (please
see 4. Previewing a track).
5.3 Set the crossfader to the side of the
deck on which the track is playing
(here, to the left).
A B
A B
5.2 You start o by playing the track on
deck A.
1
2
5
MIXING TRACKS
US
UK
To Next Page
Loading...
Need help?
General
