034-11401_1.0_24.08.2017
49
Transportation, storage and assembly
Every bicycle must be prepared so that it is in fully
usable condition immediately after being set up.
Initial commissioning includes the following work:
Check the battery [ Chapter 5.6.3.1, page 50].
The battery is supplied partially charged. In order to
guarantee full power, charge the battery fully.
Install the wheel and the pedals.
Move the handlebars and saddle into the functional
position.
Check all the components to make sure that they
are firmly in place.
Check all the settings and the tightening torque of
the axle nuts.
Check the entire cable harness to make sure that it
is routed properly:
• You must prevent the cable harness from coming into
contact with moving parts.
• The cable routes must be smooth and free from sharp
edges.
• Moving parts must not apply any pressure or tension
to the cable harness.
Set the lamp.
Check the drive system, the light equipment and
the brakes to make sure that they are fully
functional and effective.
Set the drive system has to the national language
and the appropriate system of measurement.
Check the software version of the drive system and
update it as necessary.
Axle nut tightening torque 35 Nm - 40 Nm
To Next Page
Loading...