Maintenance
034-11401_1.0_24.08.2017
90
8.2.2 Brake system
On bicycles with a rim brake, check the position of
the brake pads. The brake pads must be aligned
exactly to the rims.
Replace the brake pads on the rim brake when the
profile (check notches) has reached a remaining
depth of 1 mm.
Replace the brake linings on the disk brake when
the pad thickness has reached 0.5 mm.
8.2.3 Electrical cables and brake cables
Check all visible electrical cables and brake cables
for damage. If, for example, the sheathing is
compressed, the bicycle will need to be removed
from service until the brake cables have been
replaced.
Check all electrical cables and Bowden cables to
make sure they are fully functional.
8.2.4 Gear shift
Check the gear shift and the shifter or the twist grip
setting and adjust it as necessary.
8.2.5 USB port
Any moisture which enters through the USB port may
trigger a short circuit in the display.
Regularly check the position of the rubber cover on
the USB port and adjust it as necessary.
To Next Page
Loading...