Operation
034-11401_1.0_21.08.2017
74
1 Charging on the bicycle
When a battery has been inserted on the bicycle,
place the display in the mount for the display,
Press the On-Off button (battery).
Use the bicycle.
2 Charging using the USB port
Open the protective flap on the USB port.
Connect the USB port to a commercially available
USB charger or the USB port on a computer (5 V
charge voltage; max. 500 mA charge current),
using a suitable USB cable.
U S B CONNECTED is displayed on the display.
7.6.3 Removing and attaching the display
The system is switched off by removing the display.
Removing the display
Push the display catch down and simultaneously
push the display forwards and out of the mount.
Attaching the display
Place the display on the mount.
Push the display back as far as it will go.
If the rider is not present, the display can be used
without authorisation, e.g. it may be stolen, the system
settings may be changed or journey information may
be read.
Remove the display when the bicycle is parked.
To Next Page
Loading...