To Next PageTo Next Page
Need help?Do you have a question about the HermanMiller Nelson Thin Edge Bed and is the answer not in the manual?
General| Brand | HermanMiller |
|---|---|
| Model | Nelson Thin Edge Bed |
| Category | Indoor Furnishing |
| Language | English |
Start with bed frame facing down, requiring at least two people.
Attach center steel or wood legs using four short bolts per leg.
Attach outer legs using four short bolts per leg for both steel and wood options.
Carefully flip the bed frame to its right side up, avoiding weight on legs.
Attach wooden top rails to both ends using medium bolts, ensuring outward medallion.
Attach headboard to frame end with medallion using four short bolts per plate.
Start with bed frames facing upward, ensuring proper alignment.
Use long bolts and barrel nuts to connect frames, tightening with an allen wrench.
Carefully flip connected frames to ensure they do not bend relative to each other.
Attach large spanner plate at the foot end of the bed with six short bolts.
Attach center and outer legs using four short bolts per leg for both options.
Flip the frame to its right side up, being careful not to put weight on legs.
Attach wooden top rails using six medium bolts each, noting medallion placement.
Attach outer headboard support plates to the frame using four short bolts each.
Attach inner headboard plates and small spanner plate using eight short bolts.
