How to fix a HermanMiller Indoor Furnishing desk that does not move?
If your HermanMiller Indoor Furnishing desk isn't moving, start by ensuring it's properly connected to a power supply. Then, check all connections to the drives or side panels to confirm they are secure. Finally, verify the hand-switch is correctly plugged into the controller.
What to do if HermanMiller Indoor Furnishing desk only moves briefly on one side?
If your HermanMiller Indoor Furnishing desk only moves briefly on one side and then stops, the issue might be a loose connection to the drives or side panels. Inspect and fix the plug connector connection.
Why does my HermanMiller Nevi Indoor Furnishing desk show system protection or system pause?
If your HermanMiller Indoor Furnishing desk is experiencing system protection or system pause, it's likely that the controller has exceeded its power-on duration or maximum temperature. Allow the controller to cool down until the display shows “SP” is off. After this, you'll have 20 seconds of movement available. The table will move for the full 2 minutes only after 18 minutes.
How to resync HermanMiller Indoor Furnishing desk motors?
If the motors of your HermanMiller Indoor Furnishing desk have lost sync, and if needed, reduce the load on the table. Then, perform a reference movement.
Why is my HermanMiller Nevi Indoor Furnishing desk moving slowly?
If your HermanMiller Indoor Furnishing desk is moving slowly and you've exceeded the maximum lifting force, you need to reduce the weight on the desk.
How to fix out of sync controllers on HermanMiller Nevi Indoor Furnishing desk?
To resolve controllers out of sync (cascading) on your HermanMiller Indoor Furnishing desk, check that the cascading cable is correctly inserted between the controllers and that both controllers have a mains cable plugged in. Then, perform a reference movement.
What does overcurrent at motor 1 mean on HermanMiller Nevi Indoor Furnishing desk?
If your HermanMiller Indoor Furnishing desk indicates an overcurrent at motor 1, it might be due to a collision or exceeding the maximum load. Remove some of the load from the table.
What to do if HermanMiller Nevi desk exceeds max lifting force?
If your HermanMiller Indoor Furnishing desk has exceeded the maximum lifting force, the solution is to reduce the weight on the desk.
What happens if HermanMiller Nevi desk exceeds max operating time?
If your HermanMiller Indoor Furnishing desk has exceeded the maximum operating time, the controller will automatically reactivate after approximately 3 minutes.
Why does my HermanMiller Nevi Indoor Furnishing desk only lower slowly?
If your HermanMiller Indoor Furnishing desk only lowers slowly, the controller may need reinitialization. Please refer to Section 5 Reinitialization.
General| Brand | HermanMiller |
|---|---|
| Model | Nevi |
| Category | Indoor Furnishing |
| Language | English |
To Next Page
