HermanMiller Verus Task Chair

To Next Page

Power Driver

Tools Required

HermanMiller

Verus

Task Chair Disassembly Instructions

How to disassemble your chair.

T-

Torx Bit

13mm

socket wrench

Flat head

screw driver

T-

Torx Bit

Upholstered Back

Step 1

. Slide your ngers between the J-Bar and the cover, gently pry each

corner.

Step 2

. Take out the  bolt screws from the J-bar by using T- torx power drive.

Step 3

. Take out the upholstered back frame from J-bar.

Rubber Mallet

1 Disassembly Instructions1BN1VR rev AHermanMiller for Verus

Main Page

Need help?

Do you have a question about the HermanMiller Verus Task Chair and is the answer not in the manual?

Summary

Upholstered Back Disassembly

Step 3: Remove Back Frame

Take out the upholstered back frame from the J-bar.

Suspension Back Disassembly

Polymer Back Disassembly

Task Chair Base Disassembly

Step 8: Remove Arms

Loosen cap screws to remove arms using a 13mm socket wrench.

Step 9: Remove Seat Assembly

Activate seat slide handle and slide tilt to the end stop.

Step 10: Fixed Seat Removal

Step 11: Depress End Stop Snap

Step 12: Remove Tilt from Seat Pan

Step 13: Remove Tilt Assembly from Cylinder

Step 14: Remove Cylinder from Base

Step 15: Remove Footring

Step 17: Remove Casters

Work Stool - Upholstered Back Disassembly

Step 1: Upholstered Back Removal

Gently pry the J-Bar and cover at each corner.

Step 2: Remove J-Bar Bolts

Remove the 4 bolts from the J-bar using the T-30 torx bit.

Step 3: Remove Mesh Back

Work Stool - Suspension Back Disassembly

Step 2: Remove Back Assembly

Remove the back assembly by rotating the back forward to dis-engage hook features.

Work Stool - Polymer Back Disassembly

Step 1: Remove Hex Bolts

Remove three 13mm hex bolts using a wrench between the back and tilt.

Step 2: Remove Polymer Back Assembly

Remove the polymer back assembly by rotating the back forward to disengage hooks.