Adjustment Guide1HermanMiller Verus
™
Chair
To limit tilt range:
Turn counterclockwise to limit the level
of recline
To release tilt limiter:
Turn clockwise to increase the level
of recline
There are ve positions on the tilt limiter knob.
Engage the tilt limiter when you want to sit in an upright or partially
reclined position.
HermanMiller
Verus
™
Chair
To raise:
While taking your weight o chair,
li lever up.
To lower:
While seated, li lever up.
At the proper height, your feet should rest flat on the floor.
Seat Height: Paddle-shaped lever on right side
To increase depth:
Pull lever out, slide thighs forward to
adjust seat; release lever.
To decrease depth:
Pull lever out, push seat back and
release lever.
In the proper position, you will have approximately three-ngers of clearance
between the back of your knees and the seat edge.
Seat Depth: Lever under right side of seat
Only available on some models.
To increase tension:
While seated, turn knob forward
(toward + sign).
To decrease tension:
While seated, turn knob backward
(toward – sign).
There are six positions on the tilt tension knob.
Set the tilt tension to control the resistance you feel when leaning back.
For the Semi Synchronous tilt with Tilt Limiter, the tension is pre-loaded to
adjust to the user.
Tilt Tension: Long stem on right side with knob Tilt Limiter: Knob below le side of seat
Available on most models.
To Next Page
Need help?
General
