Hertz H8 DSP User Manual

H8 DSP
Digital Interface Processor
User’s manual
6
16
2. De-equalization analysis: H8 DSP set up.
• Press the DE-EQ SET button and check the DE-EQ CHECK LED following the instructions in the image below.
• The DE-EQ LED turns on to show that you recorded a de-equalization curve, otherwise it will be off.
• If the DE-EQ CHECK LED on the H8 DSP is on, you can run the de-equalization procedure again. The new data
will erase the ones previously stored.
*Important: Confirm or abort the de-equalization process within 5 minutes, otherwise the H8 DSP will automatically
reset and turn off.
*
*
DE-EQ CHECK LED
: ANALYZING
NO NEED DE-EQ
DE-EQ IN PROGRESS
OUT OF DE-EQ PROCESS
ABORT DE-EQ PROCESS
MEMORY CANCEL
LED OFF
LED ONDE-EQ OK
NO DE-EQ
NEED DE-EQ
END
DE-EQ SET
0,5 sec
5 sec
5 sec
1 sec
LED OFF
END

Hertz H8 DSP Specifications

General

Brand	Hertz
Model	H8 DSP
Category	Processor
Language	English