5
| hexagon.com
Device Maintenance
1. PRECAUTION
Scanner b ody
• Gently wipe the parts with a soft cotton cloth and a small amount of water or soap
Warning: Do not use solvents to clean the device.
Optical component
• Remove all particles that may scratch optical component by air blower
• Clean optical component and light source with a damp cloth such as a frictionless optical cloth or a microfiber wipe
Calibration plate
• The calibration plate should be stowed in the carrying case well. Do not place any other objects on top of the calibration plate.
Do not touch positioning targets on the calibration plate, if any positioning targets are not retro-reflective, adhesive any more or
damaged in shape, please contact with your local hexagon sales for service
• Use soft cloth to rub the industrial alcohol and gently clean retro-reflective positioning target
• Do not use acetone or solvents to clean retro-reflective positioning target
Note : The above suggestions also apply to the cleaning of optical reflectors.
Other materials
• Please use original power adapter, otherwise it may cause malfunction or damage to scanner.
• When folding the cable, the bending radius must not be less than 5 cm
• Do not squeeze or step on the cable
To Next Page
Loading...