18
4.2.2.4 Select (Measuring field)
Select a measuring field and then the layer to display the results as a graphic.
4.2.2.5 New (Measuring field)
To measure an object, a measurement field have be created with at least one
layer.
In this menu a measuring field with an associated layer can be created. A existing
measuring field can also be supplemented by a additional layer here.
The sensor must be connected to create or supplement a new layer for the
measurement field. This layer later must always be measured with the measuring head,
which was used at the time the layer was created. Otherwise, the error window "Wrong
sensorhead" appears.
1. Input of measurement array name or layer name
At the beginning a default name appears, e. g. “MEAS ARRAYnnn” or “LAYERnnn”,
with nnn being a serial number. This name can be accepted or can be adapted to your
own wishes.
The text have a maximum length of 24 characters. To edit the name use the following
buttons:
Press the arrow buttons <←> or <→> to select the character. To confirm the character
press the <ENTER> button.
To select a position of the cursor in the note press the < <Pos> button or <Pos> >
button.
The symbol
< in on the virtual keyboard is used as a backspace key to delete
inadvertently entered characters. Confirmation by <ENTER> button.
The symbol in the virtual keyboard is used to insert spaces in the note. Confirmation
by <ENTER> button.
The name is saved after pressing <ESC> button and can be edited later in the software
MOISTANALYZE.
2. Select material
Here you can select the material from a list.
To Next Page
Loading...