HF HF-LPB130 User Manual

http://www.iotworkshop.com 1 Copyright © 2013 . All rights reserved
High Flying Wi-Fi Module
Operation Guide
This document is applicable to the following series of products. This article
uses HF-LPT230 as an example to introduce the main software functions. The
differences will be specified. For the hardware description of the product and
some software functions, please refer to the user manual.
2.4GWi-Fi
HF-LPB130
HF-LPT230
HF-LPT130A
HF-LPT130B
HF-LPT330
HF-LPB135
2.4GWi-Fi
+BLE
HF-LPC300
HF-LPC330
2.4G+5G
Wi-Fi
HF-LPD100
HF-LPD130
2.4G+5G
Wi-Fi
+BLE
HF-LPF100

HF HF-LPB130 Specifications

General

Brand	HF
Model	HF-LPB130
Category	Wireless Router
Language	English

Summary

1. HARDWARE INTRODUCTION

1.1. HF-LPX30 EVK

Details the HF-LPX30 EVK development board for testing and functional development.

2. SERIAL PORT SETTINGS

2.1. SecureCRT Serial Port Tool SecureCRT

Guide to using SecureCRT for serial port communication with the module.

2.2. Setting Serial Port Parameters

Configuration of serial port parameters like baud rate, data bits, and parity.

2.3. SecureCRT Software Usage

Instructions on operating the SecureCRT software for serial port connections.

3. TEST CASE

3.1. Transparent Transmission of UART and Wi-Fi Module in AP Mode

Demonstrates data transmission between UART and Wi-Fi in Access Point mode.

3.2. Transparent Transmission of UART and Wi-Fi Module in STA Mode

Shows data transmission in Station mode, connecting to an existing Wi-Fi network.

3.3. MQTT Transmission in STA Mode

Explains how to perform MQTT data transmission in Station mode.

3.4. HTTP Transmissio in STA Mode

Details setting up HTTP data transmission in Station mode.

3.5. Heartbeat Package, Registration Package

Configuration and usage of heartbeat and registration packets for module status.

3.6. Sending AT Commands in Network Mode

How to send AT commands over the network for module control.

4. FIRMWARE UPGRADE

4.1. Serial Port Firmware Upgrade

Step-by-step guide for upgrading firmware via the serial port.

4.2. Internal Web Page Firmware Upgrade

Firmware upgrade procedure using the module's internal web interface.

4.3. External Configuration Web Page Firmware Upgrade

Upgrading firmware via an external web page configuration interface.

4.4. HF Udate Mass Production Tool Mode Upgrade

Using the HFUpdate tool for mass production firmware upgrades.

4.5. AT+UPURL Command Mode Upgrade

Firmware upgrade method using AT+UPURL command for remote updates.

5. DEBUG INFORMATION FUNCTION

6. MODULE HARDWARE DESCRIPTION

6.1. Serial Port Level Conversion

Explains serial port level conversion methods for different voltage levels.

6.2. Power Supply Design

Details the recommended LDO and DC-DC methods for module power supply.

6.3. Internal antenna

Guidelines for the placement and usage of the built-in antenna.

7. HF-LPCX30/HF-LPF100 MODULE BLE THROUGHPUT